Single Tooth Implant - Clinical Case
Below is an example of a single tooth replacement, using an implant. The bone support was adequate both in height and width, and in this case only a "cookie cutter" punch was made in the gum to access the bone. When only this minimal access is needed, there is virtually no post-operative discomfort with implant placement. Here the implant was not submerged during placement, and a healing cap was placed to keep the gum from covering over the implant. This approach is often possible with sufficient bone support, and negates the necessity of a secondary surgical procedure to expose the implant.
Single missing tooth to be replaced with implant supported crown
Drill at crest of bone, preparing to drill a hole that will receive the implant
Implant with carrier resting on plastic handle and ready for insertion
Implant and carrier in place
Healing cap screwed into implant, to keep gum from closing over implant during healing
Small punch is made in gum, revealing adequate bone width for implant
Hole prepared in bone. Notice markings on drill to determine depth of hole
Implant/carrier being placed into the prepared hole
Carrier removed, and implant seated flush with crest of bone
Side view of healing cap
